English
Arabic
-
DC ELECTRONIC LOAD / PROGRAMMABLE 8500B
The 8500B Series programmable DC electronic burdens enhance all parts of its antecedent while keeping up constancy at a worth cost. This arrangement underpins both SCPI and the regressive perfect heritage convention.
With a transient mode speed of up to 10 kHz and multi-type input terminals for banana fitting or spade connectors, these DC loads are appropriate for testing and assessing DC power supplies, DC-DC converters, batteries, battery chargers, and photovoltaic exhibits.
Most extreme info power up to 1500 W
CC/CV/CR/CW working modes
Transient mode up to 10 kHz in CC mode
16-piece voltage and current estimation framework with up to 0.1 mV/0.1 mA goals
Rundown mode and movable slew rate in CC mode
Short out test
Worked in battery test work with voltage level, limit level, and clock stop conditions
CR-LED mode to mimic the stacking conduct of regular LEDs
Remote voltage detecting to make up for the impact of voltage drop in wires
Simple current control and checking
TTL (DB9) interface, incorporates TTL to USB connector (models 8542B, 8500B, 8502B, 8510B)
USB and RS232 interfaces (8514B as it were)
OVP/OCP/OPP/OTP and neighborhood/remote opposite voltage (LRV/RRV) insurance
View the catalog -
ELECTRONIC PIPETTE / SINGLE-CHANNEL ...
there are many reasons why you need to stop utilizing mechanical pipettes and pick A&D’s MPA arrangement of single channel electronic pipettes
-
ELECTRONIC THERMOSTAT / NTC / DIGITA ...
1 probe input, 1 relay output and buzzer Available with “Sensitive Touch” and extractable terminal block.
-
ELECTRONIC THERMOSTAT / WALL-MOUNTED ...
A thermostat with an ambient model in a measuring range from 0 to +50°C. For the duct model it would be from -20 to +80°C and for the terminal block model from -100 to +400°C. The terminal block and duct mount models have an IP 65 ABS housing, for the ambient model it is IP 20. Fitted with ten-digit LCD display and one RCR relay 3A/230 Vac. The thermostat has a red LED in front and is fitted with software or DIP switch configuration. The 1/4 turn system with wall-mount plate makes it easily mountable.
-
ELECTRONIC WEIGH MODULE / INDUSTRIAL ...
Check WMF gauge module: With just 25 mm/1 inch width, completely coordinated electronic and Industrial Ethernet interface, it tends to be utilized in most testing applications with most secure space prerequisites where there is a requirement for brisk and continuous date transmission to the PLC framework.
View the catalog -
Gas Pressure Switch / Electronic / W ...
A manostat is a pressure gauge which has a switch inside its casing. At a selected pressure the switch activates an electrical contact and stops the machine on which it is wired.
View the catalog -
PITOT TUBE ANEMOMETER / WITH ALARM / ...
Crane Anemometer PCE-WSAC 50W 230 is primarily used to measure and monitor the wind load on cranes or wind turbines. Furthermore, the wind situation can be measured and analyzed before commissioning a wind turbine. The crane anemometer PCE-WSAC 50W 230 is equipped with alarm relay for a pre-alarm or main alarm.